Martin MAC Allure Wash PC User Manual page 30

Menu level 1 Menu level 2
TEST EFFECTS
TEST
(continued)**
TEST PAN/TILT
RESET
MANUAL
CONTROL**
STROBE ... FX SYNC
ERROR LIST
FAN CLEAN
PT FEEDBACK
ADJUST
SERVICE
CALIBRATION
USB
**Menus marked ** are available only when the fixture is connected to mains power. All other menus are available in mains- and
battery-powered operation.
30
Menu level 3 Menu level 4
BEAMSHAPER ... FOCUS
PAN
TILT
Empty or up to 20 errors
ON/OFF
ON
OFF
STEP 1
PAN/TILT AT END
STOP
STEP 2
DIMMER -30.00 ... 0.00%
RED -30.00 ... 0.00%
GREEN -30.00 ... 0.00%
BLUE -30.00 ... 0.00%
BEAMSHAPER I/R -25.00 ... 25.00%
ZOOM -5.00 ... 5.00%
FOCUS -5.00 ... 5.00%
PAN -2.00 ... 2.00%
TILT -2.00 ... 2.00%
LOAD DEFAULTS LOAD
SAVE DEFAULTS SAVE
NO DEVICE
UPDATING FILES
AVAILABLE XX.XX.XX ...
FIRMWARE XX.XX.XX
Table 4: Control menus
MAC Allure Wash PC User Guide
Notes (Default settings in bold print)
Run test sequence of effects.
To test a specific effect, use Up/Down
buttons to scroll through groups. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
Run test sequence of pan functions.
Press Menu button to exit test
Run test sequence of tilt functions.
Press Menu button to exit test
Reset fixture
Scroll through effects, then manually
control an effect
Display any errors in memory
Start/stop fan cleaning
Enable pan/tilt position feedback
systems
Disable pan/tilt position feedback
To adjust, move head to P/T adjustment
position, then press Enter
To adjust, move head to P/T adjustment
position again, then press Enter
Set max. dimmer intensity level
Set max. red intensity level
Set max. green intensity level
Set max. blue intensity level
Calibrate prism indexing
Set zoom home position
Set focus home position
Set pan home position
Set tilt home position
Load factory default calibration settings
Replace factory default calibration settings
with current calibration settings
No USB device present or no firmware on
USB device
Fixture updating internal memory from
USB device
Select firmware from versions stored in
internal memory. Scroll to select version,
then press Enter and confirm your choice
to update