Din-Rail Mounting; Wall Mounting (Optional) - Weidmuller IE-SW-BL05T-5TX Hardware Installation Manual

DIN-Rail Mounting

The aluminum DIN-rail attachment plate should already be fixed to the
back panel of the Ethernet Switch when you take it out of the box. If you
need to reattach the DIN-rail attachment plate, make sure the stiff metal
spring is situated towards the top, as shown in the figures below.
STEP 1:
Insert the top of the DIN-Rail into
the slot just below the stiff metal
spring.
To remove the DIN-rail from the Ethernet Switch, simply reverse Steps 1
and 2.

Wall Mounting (optional)

For some applications, you will find it convenient to mount the Ethernet
switch on the wall, as shown in the following figures.
STEP 1: Remove the
aluminum DIN-Rail
attachment plate from the
switch rear panel, and then
attach the wall mount plates
as shown in the diagram at
the right.
STEP 2:
Mounting the switch on the wall requires 4 screws.
Use the switch, with wall mount plates attached, as a
guide to mark the correct locations of the 4 screws.
The heads of the screws should be less than 6.0 mm
in diameter, and the shafts should be less than 3.5
mm in diameter, as shown in the figure at the right.
NOTE Before tightening the screws into the wall, make sure the screw
head and shank size are suitable by inserting the screw into one
of the keyhole-shaped apertures of the wall mounting plates.
Do not screw the screws in completely—leave about 2 mm to
allow room for sliding the wall mount panel between the wall and
the screws
STEP 2:
The DIN-Rail attachment unit will
snap into place as shown below.
- 8 -
6.0 mm
3.5 mm