Wiring The Redundant Power Inputs; Communication Connections - Weidmuller IE-SW-BL05T-5TX Hardware Installation Manual

ATTENTION
This product is intended to be mounted to a well-grounded
mounting surface, such as a metal panel.

Wiring the Redundant Power Inputs

The top two contacts and the bottom two contacts of the 4-contact
terminal block connector on the Ethernet Switch's top panel are used for
the Ethernet Switch's two DC inputs. Top and front views of the terminal
block connector are shown here.
ATTENTION
Before connecting the Ethernet Switch to the DC power
inputs, make sure the DC power source voltage is stable.
NOTE For use in Pollution Degree 2 Environments.
Wiring terminals shall be marked to indicate the proper
connections for power supply and load, or a wiring diagram
coded to the terminal marking shall be securely attached to the
device, and "Use Copper Conductors Only, Tighten to 4.5
pound-in."

Communication Connections

The 5-Port models have 4 or 5 10/100BaseT(X) Ethernet ports, and 1 or
0 (zero) 100 BaseFX multi/single-mode (SC/ST-type connector) fiber
ports. The 8-Port models have 6, 7 or 8 10/100BaseT(X) Ethernet ports,
and 2, 1 or 0 (zero) 100 BaseFX multi/single-mode (SC/ST-type
connector) fiber ports.
10/100BaseT(X) Ethernet Port Connection
The 10/100BaseT(X) ports located on Ethernet Switch's front panel are
used to connect to Ethernet-enabled devices. Below we show pinouts for
both MDI (NIC-type) ports and MDI-X (HUB/Switch-type) ports, and also
show cable wiring diagrams for straight-through and cross-over Ethernet
cables.
STEP 1: Insert the negative/positive DC
wires into the V-/V+ terminals.
STEP 2: To keep the DC wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal block
connector.
STEP 3: Insert the plastic terminal block
connector prongs into the terminal
block receptor, which is located on
Ethernet Switch's top panel.
- 11 -