Getting Started - Digital Check TellerScan 215 User Manual

TellerScan 215 & 230 User Manual Rev 050609
Getting Started with the TellerScan® 215 & 230
How to Load Checks
TS215 – Checks are placed into the scanner one item at a time.
1. Place the item into the entry tray with the
face of the document toward the outside.
2. Then slide the document into the path
until the leading edge contacts the 1
3. If the application is set to scan, it will start
the motor and grab the document.
TS230 – The automatic-feeder can hold up to 50 items. Use the following directions:
1. Remove all rubber bands, staples,
paper clips, pins, etc.
2. Load the items into the automatic-
feeder with the front of the items
facing away from the scanner (Fig 8).
NOTE: Checks must be jogged properly
in order to feed correctly. The bottom and
left leading edges of the check stack
must align with one another (See Fig. 7).
3. Slide the items into the automatic-
feeder until the left LED light
illuminates (Fig. 10).
4. This indicates the scanner is ready to
begin feeding the items.
force the items into the automatic-
feeder after the light illuminates, as
this may increase jam rates.
LED Status Indicators
Fig. 9: The right LED
comes on 'Red' to
indicate power to the
unit.
st
roller.
DO NOT
Fig. 10: When the
scanner is acquired by
the application, the right
LED turns green.
9
Fig. 7: bottom & left
edges aligned
Fig. 8: Front of
checks are facing out
The left LED is the
document in pocket
indicator after
acquisition.