Tellerscan® Installation - Digital Check TellerScan 215 User Manual

TellerScan 215 & 230 User Manual Rev 050609
TellerScan® 215 & 230 Installation
Un-Boxing the TellerScan® 215 & 230
Step 1:
Remove inkjet cartridge
from package slot
WARNING: Before powering on the scanner, you will want to install the USB driver. See
'Installing the Driver Files' section on page 8 for instructions.
Setting Up The Scanner
1. Place the unit on a flat surface near the PC and away from direct light.
2. Connect the power cord from the external power supply to the power connector on
the scanner rear deck. (See fig. 2 and fig. 4)
3. Place the external power supply in a ventilated area several feet away from the
scanner and connect to an appropriate source of power.
4. Make sure the TellerScan® 215 or 230 is turned off. Verify that the red power
indicator on the Control Panel is not lit. The power switch is on the rear deck. (See
Fig. 2)
5. Connect the USB cable by plugging it into the port on the rear deck. Do not turn on
the scanner until the driver has been loaded.
Fig. 4
First, plug the power
connector into the
back of the scanner.
Step 2:
Pop-out package corners.
Power Supply
6
Step 3:
Do NOT open the protective
bag. First remove the scanner
from the box by lifting up on
the bag.
Then, plug the
power adaptor
into the wall
receptacle.