Viewing Information About The Airmini; Cleaning And Maintenance; Disassembling Components; Removing The Connector - ResMed AirMini Clinical Manual

pressure level of the air delivered to the patient by the AirMini app during 95 percent of the patient's
therapy.
To access the Dashboard, tap the Dashboard icon

Viewing information about the AirMini

The About AirMini machine screen provides the following information about the AirMini:
• Total usage hours– the total number of hours the AirMini has been operated
• Firmware version– the current firmware version installed on the AirMini
Last synced– the length of time since the smart device was last synchronised with the AirMini
•
To access the About AirMini machine screen, tap About AirMini machine from the More menu.

Cleaning and maintenance

It is important that the AirMini machine is cleaned regularly to ensure optimal therapy. The following
sections will help with disassembling, cleaning and replacing parts.
WARNING
• As part of good hygiene, always follow cleaning instructions. Some cleaning products may
damage the air tubing and affect its function, or leave harmful residual vapours that could
be inhaled if not rinsed thoroughly.
• The AirMini connectors and AirFit P10 for AirMini contain a vent system to prevent carbon
dioxide build-up in the mask. The vent system must be kept clean and clear of
contamination in order to function correctly. Blocking or modifying the vent system may
result in excessive carbon dioxide rebreathing.
• Regularly clean your AirMini tubing, connectors and mask components to receive optimal
therapy and to prevent the growth of germs that can adversely affect your health.
• Regularly inspect the HumidX/HumidX Plus and follow the cleaning and maintenance
instructions to prevent the growth of germs that can adversely affect your health.
CAUTION
If any visible deterioration of a system component is apparent (cracking, discoloration, tears
etc.), the component should be discarded and replaced.

Disassembling components

The following sections provide instructions for disassembling components before cleaning.

Removing the connector

For F20 and N20 only:
Remove the connector from the mask by
pressing the side buttons and pulling the
connector away.
in the Navigation tab.
English 17