Disassembly For Repair - Kenwood NX-720 Service Manual

1. Disassembly Procedure
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
Cabinet
2. To remove the panel assembly, fi rst turn the transceiver
upside down.
Then, insert a fl at-head screwdriver into the holes of the
chassis and tilt it in the direction as shown by the arrow.
Holes
Panel assembly

DISASSEMBLY FOR REPAIR

NX-720(G)/720
3. Disconnect the fl at cable from connector of the panel as-
sembly.
4. Hook the finger to hole and while pulling the speaker
holder to this side, expand the panel side of a to c , and
remove the speaker holder from the front panel.
c
Speaker holder
5. When removing the TX-RX PCB, first remove the top
packing.
Then, remove the solder of the antenna hot pin and posi-
tive terminal of the DC cord.
Remove the 16 screws from the TX-RX PCB, power mod-
ule, and audio amp.
Positive terminal
of the DC cord
Audio amp
TX-RX PCB
Flat cable
b
a
Antenna hot pin
Power module
Top packing
9