System Set-Up; Realignment - Kenwood NX-720 Service Manual

NX-720(G)/720
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Firmware version information
Mode
User mode For normal use.
Use by the dealer to check the fundamental
Panel test mode
characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
PC tuning mode Used to tune the transceiver using the PC.
Firmware Used when changing the main program of
programming mode the fl ash memory.
Used to transfer programming data from
Clone mode
one transceiver to another.
Firmware version
Used to confi rm the internal fi rmware version.
information
4

SYSTEM SET-UP

Merchandise received
Choose the type of transceiver
Transceiver programming
(Option: NX-720(G) only)
KRA-40 GPS active antenna
Connection cable
(Option)
KES-3
External speaker
Delivery

REALIGNMENT

Panel tuning mode
Data programming mode
PC test mode PC tuning mode
Function
Frequency range (MHz)
136~174
See page 4.
A personal computer, programming interface (KPG-46A/46U),
and FPU (programming software) are required for programming.
KCT-60
(Option)
See page 7.
KCT-36
Extension cable
(Option)
KCT-18 KES-5
Ignition sense cable External speaker
See page 7.
2. How to Enter Each Mode
Mode
User mode
Panel test mode
Panel tuning mode
PC mode
Firmware programming mode
Clone mode
Firmware version information
3. Panel Test Mode
Setting method refer to ADJUSTMENT.
4. Panel Tuning Mode
Setting method refer to ADJUSTMENT.
5. PC Mode
5-1. Preface
The transceiver is programmed using a personal com-
puter, a programming interface (KPG-46A/46U) and FPU
(programming software).
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
RF power Type
25W NX-720(G)/720
(Option)
*Only when required.
(Option)
See page 8.
Operation
Power ON
[ ]+Power ON
Panel test mode+[ ]
Received commands from PC
[ ]+Power ON
[ ]+Power ON (One second)
[ ]+Power ON