Headset Connection; Using A Bluetooth ® Headset - Icom IC-A16 Full Manual

8

HEADSET CONNECTION

Using a Bluetooth
(For only transceivers with the built-in Bluetooth unit)
Transceivers with the built-in Bluetooth unit can
operate with Bluetooth headsets.
The communication range of Bluetooth is
approximately 10 meters (33 ft).
Bluetooth
®
NOTE: The Bluetooth communication range may
vary, depending on the environment where you
operate the device.
D Electromagnetic Interference
When you use a Bluetooth device, pay attention to the
following:
Bluetooth devices operate in the 2.4 GHz band. The
2.4 GHz band is also used by other devices, such
as Wireless LAN products, microwave ovens, RFID
systems, amateur radio stations, and so on.
When using this device near such devices,
interference may occur, causing a decrease in
communication speed, and an unstable connection.
In such cases, use this device away from the other
devices, or stop using those devices.
D Pairing with a device
You can pair maximum of 4 Bluetooth headsets to the
transceiver.
L These instructions describe pairing with the VS-3
Bluetooth ® headset, as an example.
1. Turning ON the transceiver's Bluetooth function
1. Push [FUNC], and then hold down [ENT]/[SET]
for 1 second to enter the Set mode.
2. Select "BT SET," and then push [ENT]/[SET].
3. Select "ON," and then push [ENT]/[SET].
4. Push [CLR]/[HOME] to exit the Set mode.
® headset
Bluetooth headset
(Example: Optional VS-3)
2. Entering the VS-3 Pairing mode
Refer to the VS-3's instruction manual for details.
3. Pairing and connecting the Bluetooth headset
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the Set mode.
2. Select "PAIRING," and then push [ENT]/[SET].
BT SET > PAIRING
• The transceiver searches for a headset.
L Push [CLR] to cancel searching.
• "SUCCESS" and " " is displayed if the headset or
device is correctly connected.
3. Push [CLR]/[HOME] twice to exit the Set mode.
D Disconnecting a paired device
You can disconnect a paired Bluetooth device if it is
not being used.
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the Set mode.
2. Select "DISCON," and then push [ENT]/[SET].
BT SET > DISCON
• "SUCCESS" is displayed and the headset is
disconnected.
3. Push [CLR]/[HOME] twice to exit the Set mode.
D Unpairing a device
Disconncet a connected headset or device before
unpairing.
1. Push [FUNC], and then hold down
[ENT]/[SET] for 1 second to enter the Set mode.
2. Select "CONNECT," and then push [ENT]/[SET].
BT SET > CONNECT
• A paired deviceʼs name is displayed.
L Push [MR]/[MW] to display the Bluetooth device
address.
L Push [∫] or [√] to select other paired headsets, if
necessary.
3. Push [FUNC], and then push [CLR]/[HOME].
• "DELETE?" is displayed.
4. Push [ENT]/[SET].
5. Push [CLR]/[HOME] twice to exit the Set mode.
12