Panasonic MEWNET-F Technical Manual page 31

Functions of each part
(1)Operation monitor LEDs ..
(2)Station number selector
switches (Rotary switches)
(3)Mode selector switches ......
(4)RS485 interface ......
(5)Input terminals, Output terminals ...
(6)Power supply terminal.............
(7)I/O monitor LEDs .................
For the information on the specifications and connections of hte I/O terminals and
power supply terminal, refer to the next page.
Indicates communication status and operation mode.
Set the station number of the MEWNET-F.Point the arrow to the
number to be used. (Set tens place and ones place separately.)
Setting range: 01 to 32
* When setting numbers exceeding the range, the setup error occurs
(ALARM LED flashes), and communication becomes impossible.
* The settings will be accepted when the power turns on.
Sets the terminal station and the output mode a communication
error occurs.
SW Setting
1､2 Terminal station setting
Output condition during a
3
communication error
* The settings of SW1 and SW2 should be the same.
* The swithces are all set to the OFF position at the factory.SW4 is
not used.
* The settings will be accepted when the power turns on.
For connecting the communication cables.
16-point input terimnals and 16-point outut terminals
(8 points for AFP87432). Including the power supply
terminal for an external device.
Supply the power to activate the I/O terminal board.
Lights up when input or output is ON.Lights off when input
or outout is OFF.
OFF
Not terminal
Terminal station
station
Maintains its
Output off
output condition
ON
2-13