Panasonic MEWNET-F Technical Manual page 148

Functions of each part
Operation monitor LEDs
Station number selector switches
Mode selector switches
RS485 interface
Power supply terminals
Expansion connector
Name Cable length
FP1
Expansion cable
11-6
Indicates communication status and operation mode.
Set the slave station number of the MEWNET-F.Point the
arrow to the number to be used. (Set tens place and ones
place separately.)
Setting range: 01 to 32
* When setting numbers exceeding the range, the setup
error occurs (ALARM LED flashes), and communication
becomes impossible.
* The settings will be accepted when the power turns on.
Sets the terminal station and the output mode a communication error
occurs.
SW Setting
1､2 Terminal station setting
Output condition during a
3
communication error
* The output when a communication error occurred is the output Y on the
FP2/FP2SH/FP3/FP10SH.The input X corresponds on the FP1.
* The settings of SW1 and SW2 should be the same.
* The swithces are all set to the OFF position at the factory.SW4 is not used.
* The settings will be accepted when the power turns on.
Terminal for connecting with the remote master station of
FP2/FP2SH/FP3/FP10SH.A transmission cable (2-wire cable) is connected.
Supply the power to activate the I/O link unit.The AC power supply type
(AFP1736) and the DC power supply type (AFP1732) are available.
Connector for connecting to a FP1 control unit or FP1 expansion unit.For
connecting the expansion cables (refer to the table below).
* A 7 cm long cable is attached to an I/O link unit as a standard accessory.
Product No.
7 cm AFP15101
30 cm AFP15103
50 cm AFP15105
OFF
Not a terminal station
Output off
Description
Standard accessory for AFP1732 and AFP1736
ON
Terminal station
Maintains its
output condition