Iii.2.4; Fan Connection - Kollmorgen Seidel 6SM56 Series Technical Description

Drawings

III.2.4

Fan connection

34
05.2000 .- A.4.029.4/07
Strip off the ends of the cores over a length of 7mm and solder them to
the contact inserts 7. Push the rubber seal 9 and the O-ring 10 onto
the insert 11. Push the insert 11 into the plug housing 8. Screw part
12 right up to the stop with an open-ended spanner (17 a/f). Push the
contact inserts from the left into the insert, observing the correct core
colour (use appropriate pliers), until they snap into position
Strip off the outer insulation of the cable
over a length of 35mm. Push the parts
1, 2‚ and 3 of the PG7 connection onto
the cable.
Push the O-Ring 5 onto the thread of
part 4 of the PG7 connection and screw
part 4 into the plug housing 6, using an
open-ended spanner (15 a/f).
Push the rubber ring 3 into the strain
relief 2. Push the cable so far through
the hole into the plug housing 6 that
about 1mm is visible. Screw up the PG
with an open-ended spanner (13 a/f).
Fit parts 6 und 8 together and screw
them together with the three screws 15.
Compress the spring ring 13 lightly and
push on the knurled sleeve 14, until it
snaps into position.
Motor series 6SM45..100
Kollmorgen