Ii.2 Assembly / Wiring - Kollmorgen Seidel 6SM56 Series Technical Description

Installation / Commissioning
II.2 Assembly / Wiring
Only qualified staff with knowledge of mechanical engineering are permitted to
assemble the motor.
Only staff qualified and trained in electrical engineering are allowed to wire up the
motor.
The procedure is described as an example. A different method may be appropriate or
necessary, depending on the application of the equipment.
Warning!
Protect the motor from unacceptable stresses.
Take care, especially during transport and handling, that components are not bent
and that insulation clearances are not altered.
Always make sure that the motors are de-energized during assembly and wiring,
i.e. No voltage may be switched on for any piece of equipment which is to be
connected.
Ensure that the switch cabinet remains turned off (barrier, warning signs etc.).
The individual voltages will only be turned on again during commissioning
Note!
The ground symbol
you must provide an electrical connection, with as large a surface area as possible,
between the unit indicated and the mounting plate in the switch cabinet. This con-
nection is to suppress HF interference and must not be confused with the PE
(protective earth) symbol
To wire up the motor, use the wiring diagrams in the Installation and Commis -
sioning Instructions of the servo-amplifier which is used.
18
05.2000
X
, which you will find in the wiring diagrams, indicates that
W
(protective measure to EN 60204).
Kollmorgen
Motor series 6SM45..100