Table of Contents
Advertisement
5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
(1.5 meters) off the ground, in an open area. Higher is better for wind
measurements- the National Weather Service recommends 33 feet (10 meters)
high!
MOUNTING OPTIONS
directly onto wooden posts or surfaces that are 2"x4" or larger. The
sensor can also be mounted directly to 3/4" steel pipe (available at
hardware stores and home centers).
SOLAR CELL INSTALLATION
sensor with the solar cell facing SOUTH.
This ensures the cell receives as much sun
as possible and orients wind direction.
5-in-1 Sensor Installation
1. Fasten mounting base (included) to a
post or pole (not included) using the 4
longer screws included in the hardware
bag.
2. Insert the mounting base into the hole
on the bottom of the sensor.
3. Make sure the arrows on the top of
the sensor are pointed in the proper
direction and the bubble level is
centered. The solar cell should be
facing south to properly orient the
wind direction.
4. Fasten the sensor into the mounting
base using the 2 shorter screws included in the hardware bag.
Clear Data Collected During Installation
When installation is complete, clear erroneous data from the display unit by
pressing the "CLEAR RECORD/ RESET" button, on the back of the display
inside the battery compartment. This button will clear data recorded since
12:00 am.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. If both or one of the units appear to
Mount the sensor at a minimum height of 5 feet
The included mounting bracket is designed to screw
Install the
The 5-in-1 sensor is now ready to use.
NO OBSTRUCTIONS
ABOVE OR AROUND
T H
S O U
13
(1.5 meters)
Advertisement
Table of Contents
