Waveform Record - UNI-T UTD2000CEX-II Series User Manual

Template settings menu
Options Descriptions
Functions
Select a channel CH1,CH2 with horizontal
CH1,CH2
Reference Waveform
and vertical tolerance as a template
Use the multipurpose knob to
Horizontal Tolerance 1~255
select the horizontal tolerance
Use the multipurpose knob
Vertical Tolerance 1~255
to select the vertical tolerance
Create Template Create template with above conditions
Return to previous menu
Return
(2) Application Example
Iinput 1kHz, 3V square wave from CH1, observe the result of the pass test:
Pass Test
The test function will run continously and stop once 10 fail tests have been
reached, or the user manually suspends the test (when operation is set to
close).
① To enter the test menu: Press UTILITY, then press F5 to enter auxiliary
menu second page, then press F2 to enter the test menu.
② Set the test: press F1 to enable the test set
③ Set the source: press F3 to set the source to CH1
④ Template settings: press F5 to enter the next page, then press F3 to enter
the template settings menu. Press F1 to select the reference waveform
to CH1; press F2 and F3, set the level threshold with the multipurpose
knob to 10, set the vertical threshold to 5, then press F4 to create a template,
press F5 to return to the test menu
⑤ Stop setting: press F2 to enter stop setting menu, set the stop type to
pass count, and set the threshold to 10 with multipurpose knob, press
F5 to return to the test menu
⑥ Set the output conditions: press F5 to return to the first page of the test
menu, set the output condition to 'fail' using the F2 key
⑦ Open display information: press F4 to set display information to open
⑧ Start test: press F5 to enter the second page of the test menu, then press
F1 to open the operation to start the test. See figure below:

11.4 waveform record

Press UTILITY, then press F5 to enter the secondary menu, then press F1
to enter the waveform record menu .
Waveform record menu
UTD2000CEX-II
User Manual