UNI-T UTD2000CEX-II Series User Manual page 35

UTD2000CEX-II
User Manual
11.3 Pass Test
The pass (fail) test is by using a template to detect whether the input signal
satisfies the template requirements.
(1) Function Introduction
Press UTILITY, then press F5 to enter the secondary menu, then press F2
to enter the test menu.
Pass Test Menu (1)
Options Descriptions
Functions
Close Close Pass Test
Allow Test
Open Open Pass Test
Set the Pass/Fail interface on the
rear panel : output pulse signal
Fail
and produce buzzing when "failure"
Output
et the Pass/Fail interface on the rear
panel : output pulse signal and
Pass
produce buzzing when "pass"
Set the source of the pass test
Source CH1、CH2
Turn off display information
Close
Display Info
Open Turn on display information
Enter Pass Test Menu (2)
½
Pass Test Menu (2)
Functions Options
Close
Operation
Open
Stop Setting
Template Setting
2/2
After opening the pass test, you need to set the stop settings and template
settings before you can perform the test function. Otherwise you'll be
prompted "Function is Disabled". The stop setting and template settings
menus are shown as below.
Stop settings menu
Options Descriptions
Functions
The test function stops after it reaches
Pass Count
a specified pass count number
Stop Type
The test function stops after it
Fail Count
reaches a specified fail count number
>=、<=
Stop condition setting
Condition
Use the multipurpose knob to
Threshold
select stop condition threshold
Return to previous menu
Return
Descriptions
Disable Pass Test
Enable Pass Test
Enters Stop Settings Menu
Enters Template Settings Menu
Return to Pass Test Menu (1)