Vrrp Mode - H3C WX Series Command Reference Manual

By default, the virtual MAC addresses are mapped to the virtual IP addresses of the VRRP groups.
Specify the type of the MAC addresses mapped to the virtual IP address before creating a VRRP group.
Otherwise, you cannot change the type of the MAC address by using this command. .
When VRRP is operating in load balancing mode, a virtual IP address is always mapped to a virtual
MAC address regardless of which type of the MAC addresses to be mapped to the virtual IP address is
specified.
Related commands: display vrrp.
Examples
# Map the virtual IP address of a VRRP group to the real MAC address of the interface.
<Sysname> system-view
[Sysname] vrrp method real-mac

vrrp mode

Syntax
vrrp mode load-balance
undo vrrp mode
View
System view
Default Level
2: System level
Parameters
load-balance: Specifies the load balancing mode.
Description
Use vrrp mode to configure the VRRP working mode.
Use undo vrrp mode to restore the default.
By default, VRRP operates in standard protocol mode.
When VRRP is operating in load balancing mode, the virtual IP address cannot be the same as the
•
IP address of any interface in the VRRP group, and the virtual IP address should be mapped to the
virtual MAC address. Otherwise, VRRP cannot operate in load balancing mode.
When a VRRP group is created, you can still change the VRRP working mode. When you change
•
the VRRP working mode, all VRRP groups on the access controller operate in the specified mode.
Related commands: display vrrp.
Examples
# Configure VRRP to operate in load balancing mode.
<Sysname> system-view
[Sysname] vrrp mode load-balance
13