H3C WX3500H Series Installations

H3C WX3500H Series Access Controllers Installation Quick Start-6W104
H3C WX3500H系列无线控制器 快速安装指南-6W104
The WX3500H Series Access Controllers include the WX3510H, WX3520H and WX3540H models.
The installation procedures are the same for the three models. This guide uses the WX3540H
access controller as an example.
WX3500H系列包括WX3510H、WX3520H和WX3540H三款无线控制器，安装方式完全相同，本文
以WX3540H为例介绍设备的安装过程。
Tool list 工具参考
The installation tools are not provided with the access controller. Prepare them yourself.
设备不随机提供安装工具，请用户根据实际安装需求自己准备安装工具。
Phillips screwdriver
Flathead screwdriver
一字螺丝刀 十字螺丝刀
Diagonal pliers
Heat gun
热风枪 斜口钳
Introduction to installation accessories 安装附件介绍
Grounding cable Cage nut
(user-supplied)
(provided)
地线（标配） 浮动螺母（用户自备）
Rubber feet Console cable
(provided) (provided)
脚垫贴（标配） 配置电缆（标配）
Needle-nose pliers Wire-stripping pliers
尖嘴钳 剥线钳
Marker
ESD wrist strap
记号笔 防静电腕带
M6 screw Mounting bracket
(user-supplied) (provided)
M6 螺钉（用户自备） 挂耳（标配）
Removable cable tie
(user-supplied)
可拆卸式扎带（用户自备）
Wear an ESD wrist strap, and make sure the wrist strap makes good skin contact and is reliably
!
grounded.
操作者需佩戴防静电腕带，确保防静电腕带与皮肤良好接触，并确认防静电腕带已经良好接地。
Mounting the access controller on a workbench 安装设备
到工作台
Make sure the workbench is stable and reliably grounded.
Do not place heavy objects on the access controller. Attach
the rubber feet to the four round holes in the chassis bottom.
Place the access controller on the workbench.
保证工作台的平稳与良好接地，并且不要在设备上放置重物。
粘贴脚垫贴到设备底部，将带脚垫贴的设备平放到工作台上。
Airflow of the access controller 设备的风向设计
Make sure the air inlet and outlet vents are not blocked and the installation site has a good ventilation system.
请确保设备的进、出风孔不被遮挡，并将设备安装在具有良好通风散热系统的环境中。
BOM:3104A0FG
Left-to-right airflow.
设备采用左进右出的风道设计。