Smeg PS906 Instructions For Installation And Use Manual page 13

Instructions for the installer
Important: other types of installation are possible if supervised by the
manufacturer.
Important: for fixing this appliance to the support structure, you are
advised not to use mechanical or electrical screwdrivers and to exert
moderate pressure by hand on the mounting parts.
Important: for fixing the appliance, use the supplied brackets in all the
fixing points.
If this appliance is installed over an oven, the oven must have a cooling
fan.
Important (only for Ultra-rapid burners (UR3) (5) with raised pan
stands): if the appliance is mounted on a unit, make sure that a
separating shelf is installed, as shown in the figure.
If the appliance is instead on an oven installed under the hob, there is no
need to install a separating shelf.
If installed over an oven, the oven must have a cooling fan.
8.2 Electrical connection
Make sure that the voltage and capacity of the power line conform to the
data shown on the plate located under the casing.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than 3 mm,
in an easily accessible position close to the appliance.
34