Table of Contents
Advertisement
Quick Links
1.
INSTRUCTIONS FOR SAFE AND PROPER USE _______________ 4
2.
INSTALLATION OF THE APPLIANCE_________________________ 6
3.
GAS CONNECTION _______________________________________ 9
4.
ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 11
5.
FINAL OPERATIONS _____________________________________ 13
6.
USE OF THE COOKING HOB ______________________________ 14
7.
CLEANING AND MAINTENANCE ___________________________ 16
8.
PROBLEMS AND CAUSES ________________________________ 18
Thank you for choosing our product.
We advise you to read this manual carefully. It contains all necessary
instructions for maintaining unaltered the appearance and functional
qualities of the hob.
INSTRUCTIONS FOR THE INSTALLER: these are for the qualified
technician who must carry out a suitable check of the gas system,
install the appliance, set it functioning and carry out an inspection test.
INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for cleaning
and maintenance of the appliance.
Contents
3
Advertisement
Table of Contents
Related Manuals for Smeg PLDA21AC
Summary of Contents for Smeg PLDA21AC
-
Page 1: Table Of Contents
CLEANING AND MAINTENANCE ___________________________ 16 PROBLEMS AND CAUSES ________________________________ 18 Thank you for choosing our product. We advise you to read this manual carefully. It contains all necessary instructions for maintaining unaltered the appearance and functional qualities of the hob. -
Page 2: Instructions For Safe And Proper Use
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKING HOB. - Page 3 DO NOT USE RECIPIENTS OR GRIDDLE PLATES THAT EXTEND BEYOND THE EXTERNAL PERIMETER OF THE HOB. THE HOB IS TO BE USED BY ADULTS ONLY. DO NOT LET UNSUPERVISED CHILDREN PLAY WITH THE HOB. REPLACED APPLIANCES MUST BE TAKEN TO A SPECIAL GARBAGE COLLECTION CENTRE.
-
Page 4: Installation Of The Appliance
Make sure there is a minimum of 750 mm between the hot plate flames and any shelf that may be installed directly above them. To fix the appliance to the worktop,... - Page 5 600 mm or, for an overhead exhaust fan, 750 mm. Any other downward facing combustible surface less than 600 mm above the highest part of the hob shall be protected for the full width and depth of the cooking surface area in accordance with Clause 5.12.1.2.
-
Page 6: Room Ventilation
Instructions for the installer than 150 mm above the hob for the full dimension (width or depth) of the cooking surface area. Where the cooking appliance is fitted with a ‘splashback’, protection of the rear wall is not required. 3 Additional requirements for Freestanding and Elevated Cooking Appliaces –... -
Page 7: Gas Connection
2 large size burners are used. Ensure appliance is secured to wall when installation is completed. N.G. The regulator supplied must be fitted to the ½ BSP thread at the rear of the appliance. An approved manual shut-off valve must be installed. -
Page 8: Electrical Connection
Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electrical system regulations. -
Page 9: Adaptation To Different Types Of Gas
Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The cooker hob is set for natural gas G20 (2H) at a pressure of 20 mbar for cookers with maxi oven, and for LPG G30/G31 (3+) at a pressure of 28/37 mbar for cookers with gas-bottle compartments. -
Page 10: Burner And Nozzle Characteristics Table
Instructions for the installer 4.2 Burner and nozzle characteristics table Burner LPG – 2.75 kPa Nominal gas Injector consumption (mm) (MJ/h) Auxiliary (1) 0.54 Semi rapid (2) 0.68 Rapid (3) 10.8 0.88 WOK (4) 13.5 1.00 Burner NG – 1.0 kPa... -
Page 11: Final Operations
Burner and nozzle characteristics table”. 5.3 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and re-grease them. This operation must be done by a specialised technician. -
Page 12: Use Of The Cooking Hob
The optional grid B is for use with “woks” (Chinese pans). To prevent damage to the worktop, the hob is equipped with a raised grid C: installs over pans larger than the diameter shown in the table in paragraph " 6.3 Diameter of receptacles". Note that pans larger than 30 cm diameter must be used only on the central burner. - Page 13 6.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “6.3 Diameter of containers”).
-
Page 14: Cleaning And Maintenance
To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids. How to use: pour the product on a damp cloth and wipe the surface, rinse thoroughly and dry with a soft cloth or deerskin. - Page 15 Valves: if the gas valves get stuck or hard to turn, they need to be cleaned and re-greased; this operation must be carried out by an...
-
Page 16: Problems And Causes
Instructions for the user 8. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should be dealt with by an authorised perso: please contact your local dealer or Service Center in case you detect any of these malfunctioning.