Table of Contents
Advertisement
Instructions for the installer
8.1.2 Fixing to the electric model support structure
Create an opening in the counter top with the dimensions shown in the
figure, keeping a minimum distance of 50 mm from the rear edge. The
lower part of the casing must be fully accessible after the appliance has
been installed.
This appliance can be mounted
against walls higher than the work
surface on condition that a distance
of
"X" be kept between the
appliance and the wall as shown in
the figure so as to avoid damage
from overheating. Make sure that
there is a minimum of 750 mm (Fig.
1) between the hob and any shelf
that may be installed directly above
it.
This type of appliance also
2)
requires milling to a depth of 3
mm on the counter top with the
dimensions shown in figure 2
(detail A). Before positioning
E
73
the hob, the supplied adhesive
sponge "E" (fig. 2) must be
spread out over the entire
surface of the milling.
R 14.5
A
A
32
Hide quick links:
Advertisement
Table of Contents
