Troubleshooting; Introduction - Troubleshooting; Fault Messages - Husqvarna AUTOMOWER 535 AWD Operator's Manual

7.1 Introduction - troubleshooting

In this chapter, a number of messages are listed which may be shown in Automower
malfunction. There is a proposal as to the cause and steps to take for each message. This chapter also presents
some symptoms that can guide you if the product does not work as expected. More suggestions for steps to take in
the event of malfunction or symptoms can be found on www.husqvarna.com.

7.2 Fault messages

The table below shows a number of fault messages that may be shown in Automower
can be confirmed in the Automower
your local Husqvarna representative if the same message appears often. For more information, refer to
page 25 .
Message Cause
Trapped
The product is stuck in a small area behind a
number of obstacles.
Wheel motor blocked Grass or other object has wrapped around
the drive wheel.
Wheel drive problem
Cutting system Grass or other object has wrapped around
blocked
the blade disc.
The blade disc lies in a pool of water.

34 - Troubleshooting

7 Troubleshooting
®
Connect and some the message needs to be confirmed on the product. Contact
®
Connect if there is a
®
Connect. Some of the errors
Action
Examine if there are any obstacles which
make it hard for the product to move away
from this location.
Examine the drive wheel and remove the
grass or other object.
Examine the blade disc and remove the
grass or other object.
Move the product and prevent the collection
of water in the work area.
1427 - 009 - 20.12.2022
Messages on