General Safety Instructions; Terms And Symbols; Warnings - VTI Instruments EX1629 User Manual

VTI Instruments Corp.
Review the following safety precautions to avoid bodily injury and/or damage to the product.
These precautions must be observed during all phases of operation or service of this product.
Failure to comply with these precautions, or with specific warnings elsewhere in this manual,
violates safety standards of design, manufacture, and intended use of the product.
Service should only be performed by qualified personnel.
T S
ERMS AND YMBOLS
These terms may appear in this manual:
WARNING
CAUTION
These symbols may appear on the product or in the manual:
W
ARNINGS
Follow these precautions to avoid injury or damage to the product:
Use Proper Power Cord
Use Proper Power Source
Use Proper Fuse
12
G S
ENERAL AFETY
Indicates that a procedure or condition may cause bodily injury or death.
Indicates that a procedure or condition could possibly cause damage to
equipment or loss of data.
ATTENTION - Important safety instructions
Indicates hazardous voltage.
Frame or chassis ground
Indicates that the product was manufactured after August 13, 2005. This mark is
placed in accordance with EN 50419, Marking of electrical and electronic
equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE).
End-of-life product can be returned to VTI by obtaining an RMA number. Fees
for take-back and recycling will apply if not prohibited by national law.
To avoid hazard, only use the power cord specified for this product.
To avoid electrical overload, electric shock, or fire hazard, do not
use a power source that applies other than the specified voltage.
To avoid fire hazard, only use the type and rating fuse specified for
this product.
I
NSTRUCTIONS
EX1629 Preface