Selecting A Job To Build - Stratasys Fortus 380mc Operation And Maintenance Manual

SELECTING A JOB TO BUILD

1. Select the Queue button within the Navigation Bar. The Queue page will open, and the Job
Queue tab will be selected by default.
2. Within the Job Queue, select the job you wish to build by touching its entry in the list; the job's
row will turn blue. After selecting a job the Build State button will turn green.
• If you wish to select a job from the Sample Queue, toggle to the Sample Queue by touching its
header within the Queue page and then selecting the job you wish to build by touching its entry
in the list.
3. Return to the Build page by selecting the Build button from the Navigation Bar. The details of the
job you selected will be displayed within the Print Job Selection Panel.
4. Compare the materials/tips requirements of the selected job to the printer's current configuration.
Ensure that loaded materials match the material requirements of the selected job, and installed
tips match the tips required by the selected job.
If the model and/or support materials loaded in the printer do not match the materials required
•
to complete the build you will receive a warning.
5. Ensure that the active model and support canister bays have filament loaded to the head.
6. Press the Build (play) button within the Build page to start the build.
• If the Enable Part Placement setting is set to Off (default setting), a dialog will not be displayed
and the job will automatically be built in the center of the build sheet.
If you set the Enable Part Placement setting to On, a dialog will be displayed allowing you to
•
select the job's build location. The dialog contains a graphic representing your printer's platen
as well as a blue bounding box graphic (the imaginary box surrounding the part). Select the
job's build location by dragging and dropping the bounding box on the touchscreen. When
finished, press the checkmark button to confirm your selected placement and start the build.
70