Turning Off The Dvrs; Deactivating The Dvrs Via The Msu Control Head; Deactivating The Dvrs Via Call Alert Sent By Dispatch - Futurecom DVRS User Manual

Turning OFF the DVRS

Deactivating the DVRS via the MSU Control Head

To deactivate the DVR via the MSU control head:
•
Press the DVRS button to enter the 'DVR Control Mode', then press the MODE
button until VR OFF is displayed and either press the SEL button or wait for the
screen timeout (6 seconds).
OR
•
Select a 'DVR Disabled' TG / Mode / Zone on the MSU
OR
•
Power down the MSU if radio operation is no longer required.

Deactivating the DVRS via Call Alert sent by Dispatch

Dispatcher can send a Call Alert (Page) to a specific MSU ID, which in turn causes DVR
mode change in the following order: OFF-SYS-LOC-OFF.
The MSU can be programmed to support one of the following configurations:
a. Call Alert / Remote Activation Disabled – the MSU does not respond to any Call
Alert requests
b. Call Alert Enabled – the MSU responds to Call Alerts addressed to its ID and
does NOT initiate DVRS mode change
c. Remote Activation Enabled – the MSU will acknowledge Call Alerts addressed to
its ID and will initiate DVR mode change provided the source ID of the Call Alert
is programmed in the "DVR Remote Activation IDs" table.
If "Generate Status on DVR Mode Change" is enabled for a given DVRS Profile (in the
APX MSU) , the MSU will send back a mode change status to indicate the current DVRS
mode (OFF, SYSTEM, LOCAL). Only the dispatcher console can interpret those status
messages:
Dispatcher can't force a Non-Primary DVR to become a Primary and can't activate a
DVR when a 'VR Disabled' mode is selected on the control head.
January 2019
DVR MODE
OFF
LOCAL
SYSTEM
APX Series P25 Interface
DVRS User's Guide
STATUS VALUE
1
2
3
8A083X30 Rev.11
Page 30 of 94