Rf Energy Exposure Compliance, Awareness And Control Information And Operational Instructions - Futurecom DVRS User Manual

8A083X30 Rev.11
APX Series P25 Interface
DVRS User's Guide
RF Energy Exposure Compliance, Awareness and
Control Information and Operational Instructions
ATTENTION!
Changes or modifications not expressly approved by Futurecom Systems Group,
ULC. could void the User's authority to operate the equipment. To satisfy
FCC/ISED RF exposure requirements for mobile transmitting devices, the
minimum separation distances specified in the RF Safety Booklet 8F083X03(FCC)
or 8F083X05(ISED) shipped with the DVRS should be maintained. To ensure
compliance, operations at closer than this distance is not allowed.
ATTENTION!
Futurecom requires the P25 DVRS operator to ensure FCC/ISED Requirements for
Radio Frequency Exposure are met. The minimum distance between all possible
personnel and the body of the DVRS equipped vehicle is specified in the "RF
Safety" book shipped with the DVR. Failure to observe the Maximum Permissible
Exposure (MPE) distance exclusion area around the antenna may expose persons
within this area to RF energy above the FCC exposure limit for bystanders
(general population). It is the responsibility of the repeater operator to ensure MPE
limits are observed at all times during repeater transmissions. The repeater
operator must ensure at all times that no person comes within MPE distance from
the vehicle body.
ATTENTION!
The Transportable (suitcase) DVRS ships without an APX Mobile radio. Once an
APX Mobile radio is installed, refer to the Product Safety and RF Exposure booklet
8F083X03(FCC) or 8F083X05(ISED) enclosed with your DVRS. Refer to the vehicle
installation guidelines for vehicle installation. For fixed site installation, refer to
the Fixed DVRS Site Antennas section.
January 2019 Page 13 of 94