Drawer Leds; Ddic Leds - Dell EMC ME4 Series Owner's Manual

LED Status/description
Drawer 1 Amber indicates a disk, cable, or sideplane fault in drawer 1. Open the drawer and check DDICs for faults.
Fault

Drawer LEDs

See #unique_41/GUID-584C583E-8246-4808-8F6E-438F4FF90117
drawer bezel.
Table 18. Drawer LED descriptions
LED Status/description
Sideplane Green if the sideplane card is working and there are no power problems.
OK/Power
Good
Drawer Fault Amber if a drawer component has failed. If the failed component is a disk, the LED on the failed DDIC will light amber.
Follow the procedure in
failure, and resolve the problem.
Logical Fault Amber (solid) indicates a disk fault. Amber (blinking) indicates that one or more storage systems are in an impacted state.
Cable Fault Amber indicates the cabling between the drawer and the back of the enclosure has failed. Contact your service provider
to resolve the problem.
Activity Bar Displays the amount of data I/O from zero segments lit (no I/O) to all six segments lit (maximum I/O).
Graph

DDIC LEDs

The DDIC supports LFF 3.5" and SFF 2.5" disks. The following figure shows the top panel of the DDIC as viewed when the disk is aligned
for insertion into a drawer slot.
Figure 36. LEDs: DDIC – 5U enclosure disk slot in drawer
1 Slide latch (slides left)
3 Drive Fault LED
Table 19. Drawer LED descriptions
Fault LED (Amber)
Off
Off
Blinking: 1s on/1s off
38 Troubleshooting and problem solving
Replacing a DDIC. If the disks are OK, contact your service provider to identify the cause of the
Status/description*
Off (disk module/enclosure)
Not present
Identify
for a visual description of the Drawer LED inserts located on each
2 Latch button (shown in the locked position)