Nucraft Saber Collection Installation Instructions

Saber Collection
If you have any questions regarding installation, please call
Nucraft Customer Service at 1- - - - 877 Nucraft Customer Service at 1 Nucraft Customer Service at 1 Nucraft Customer Service at 1

Tools Required:

Tools Required: Tools Required: Tools Required:
Phillips Head Screwdriver
1/4" Allen Wrench
5/32" Drill Bit
Note: Sight-Line Tables use different width Bases for the narrow end Note:
Note: Note:
versus the middle and wide end of the table. Shorter Tables (i.e. 120"
and 144") omit the Center Base.
1. End Base Installation: Loosen (Do not remove) 5/16" Cap Screws
attached to Clamp Bars (See Figure 1)
2. Slide Main Beams into position with the Clamp Bars aligned in
the slots of the Main Beam
(See Figures 1 & 2)
Note: Note: For sightline Note: Note: For sightline For sightline For sightline with
s s s s horter be horter be horter beams mounted between wider horter be ams mounted between wider bases ams mounted between wider ams mounted between wider
3. Beams should overhang the Base as following;
Note: Dimensions are approximate. Saber allows the Bases
to be positioned where needed for floor core locations,
etc. (See Figure 2)
a. 48" Wide Tables
I. Panel Base = 5"
II. Column Base = 1"
b. 60" Wide Tables
I. Panel Base = 11"
II. Column Base = 7"
4. Using the Allen Wrench, tighten Cap Screws to secure
Bases to the Main Beams
ID034 – Saber Conference Installation
Revision M – 8/12
Pg. 1 of 2
Installation Instructions
™
877 877- - - - NUCRAFT 877 NUCRAFT NUCRAFT NUCRAFT
with with with center center column base center center column base only column base column base
bases. . . . bases bases
only only only
Figure 1 Figure 1
Figure 1 Figure 1
Figure 2 Figure 2 Figure 2 Figure 2