Description; Physical Description; Technical Description - Satelec IMPLANT CENTER 2 User Manual

- Use of accessories from other manufacturers is
a potential hazard for you or your patients.
Repair:
- Warning: Do not repair or modify the device
without prior authorization from SATELEC.
- Warning: If the device is modified or repaired,
specific checks and tests must be performed to
ensure that the device can still be used safely.
- In the case of a fault, contact the supplier of
your device. Do not use unauthorized repairers,
who might make your device dangerous for you
and your patients.
If in any doubt, contact an approved dealer or our
customer support department:
- www.acteongroup.com
- E-mail: satelec@acteongroup.com.
III - DESCRIPTION

3. 1 PHYSICAL DESCRIPTION

The I C
MPLANT ENTER
components:
- a control unit (Fig. 1),
- a multifunction footswitch (Fig. 11),
- a micro-motor cord with connectors (Fig. 1-2),
- two brackets for irrigation solution (Fig. 1-3),
- an I-S micro-motor (Fig. 1-4) without
URGE
contra-angle,
- a grounded power cord (Fig. 1-5),
- an LCD (Liquid Crystal Display) touch screen
(Fig. 1-6),
- a motor cord connector (Fig. 1-7),
- two peristaltic pump housings (Fig. 1-8),
2 has the following
- a cord connector for the two ultrasonic
functions (Fig. 1-9),
- a N scaler cord or P
EWTRON
handpiece with cord (Fig. 1-10) (according to
option),
- a N L handpiece or a P
EWTRON ED
handpiece with its cord (Fig. 1-11) (according to
option).
Located at the back of the unit are:
- 1 power cord socket with ground pin (Fig. 2-1),
- 1 footswitch connector (Fig. 2-2),
- 1 fan (Fig. 2-3),
- 2 bracket holders (Fig. 2-4),
- 1 power switch (Fig. 2-5).

3. 2 TECHNICAL DESCRIPTION

a) LCD touch screen
The LCD touch screen (Fig. 3) is used to define
the settings of your I
The I C
MPLANT ENTER
moderate pressure to the screen keys.
Identification of key areas common to all modes
(Fig. 3):
- 4: Reduce irrigation flow rate.
- 5: Increase irrigation flow rate.
- 6: Reduce value.
- 7: Increase value.
Identification of information display areas
common to all modes (Fig. 3)
- 2: Irrigation flow rate value.
- 9: Operating fault indicator.
Identification of key areas common to all modes
that also display information (Fig. 3)
- 1: Flush/prime.
- 3: Irrigation ON/OFF.
- 8: Save, store data.
- 10: Select footswitch mode.
IEZOTOME
IEZOTOME
C 2.
MPLANT ENTER
2 is adjusted by applying
2 L
ED
2 L
ED
7