Newtron Function; Toolbox - Satelec IMPLANT CENTER 2 User Manual

Repeat this sequence if necessary in order to
adjust all the programs.
Caution: The tips designed for P
I C 2 are not compatible with
MPLANT ENTER
P and I
IEZOTOME MPLANT

7. 7 NEWTRON FUNCTION

Important:
A scaler cord and its N
be connected to the device in order to be able
to configure the various settings.
The N function settings can be
EWTRON
customized by the user.
Select the N
EWTRON
(Fig. 3-12) or by pressing the footswitch
button (Fig. 11-5).
On the LCD screen, the N
highlighted.
Select the program for which settings are to be
adjusted by pressing buttons
or (Fig. 5-16) or by pressing the
footswitch button (Fig. 11-3).
Adjust the power level according to the TipBook
recommendations.
If necessary, modify the program power level (1
to 10) using buttons
3-7).
The power level of the program concerned is
shown as a number and a bar-graph
5-15).
IEZOTOME
C , and vice versa.
ENTER
handpiece must
EWTRON
function by pressing button
tab must be
EWTRON
,
(Fig. 3-6) and
Modify the footswitch type if necessary by
pressing button
2 and ON/OFF and progressive.
If necessary, select handpiece light function
ON/OFF by pressing button
Confirm the new settings by pressing button
(Fig. 3-8). The saving of the various settings is
confirmed by an audible signal and a visual signal
(flashing button).
Repeat this sequence if necessary in order to
adjust all the programs.

7. 8 TOOLBOX

Important:
I C
MPLANT ENTER
make various
brightness, light off time-out, audio volume
, and factory configuration reset.
To access the T
device, wait four seconds, switch the device ON
again, then press button
welcome screen (Fig. 9).
a) Audio volume adjustment
(Fig.
Adjust the audio volume value
(Fig. using buttons
The audio volume is adjustable from 0% to 100%.
(Fig. 3-10) to toggle between
(Fig. 3-11).
2 has a T function used to
OOLBOX
adjustments,
function, switch OFF the
OOLBOX
(Fig. 9-41) on the
and (Fig. 10-46 and 47).
including
(Fig. 10-43)
17