Newtron Function; Toolbox - Satelec Implant Center 2 User Manual

and progressive
Important:
In progressive mode, for programs D1 to D3, the
delivered power ranges between power level 1 of
program D3 and the configuration defined by the
user (program and power level).
In progressive mode, the power delivered by
program D4 ranges only between levels 1 and 5,
according to the value defined by the user.
If necessary, select handpiece light function ON/OFF
by pressing button
Confirm the new settings by pressing button
(Fig. 3-8).
The saving of the various settings is confirmed by an
audible signal and a visual signal (button flashing).
Repeat this sequence if necessary in order to adjust
all the programs.
Caution: The tips designed for P
I C 2 are not compatible with P
MPLANT ENTER
and I C , and vice versa.
MPLANT ENTER

7. 7 NEWTRON FUNCTION

Important:
A scaler cord and its N
be connected to the device in order to be able to
configure the various settings.
The N L
EWTRON ED
customized by the user.
Select the N
EWTRON
(Fig. 3-12) or by pressing the footswitch
button (Fig. 11-5).
On the LCD screen, the N
highlighted.
Select the program for which settings are to be
adjusted by pressing buttons
.
(Fig. 3-11).
IEZOTOME
L handpiece must
EWTRON ED
function settings can be
function by pressing button
tab must be
EWTRON
,
or
button (Fig. 11-3).
Adjust the power level according to the TipBook
recommendations.
If necessary, modify the program power level (1 to
10) using buttons
The power level of the program concerned is shown
as a number and a bar-graph
Modify the footswitch type if necessary by pressing
button
progressive.
If necessary, select handpiece light function ON/OFF
by pressing button
Confirm the new settings by pressing button
2 and 3-8). The saving of the various settings is confirmed
by an audible signal and a visual signal (flashing
IEZOTOME
button).
Repeat this sequence if necessary in order to adjust
all the programs.

7. 8 TOOLBOX

Important:
I C
MPLANT
make various adjustments, including screen
brightness, handpieces light off time-out, audio
volume and factory configuration reset.
To access the T
device, wait four seconds, switch the device ON
again, then press button
welcome screen (Fig. 9).
,
(Fig. 5-16) or by pressing the footswitch
(Fig. 3-6) and
(Fig. 3-10) to toggle between ON/OFF and
(Fig. 3-11).
2 has a T
ENTER
OOLBOX
function, switch OFF the
OOLBOX
(Fig. 3-7).
(Fig. 5-15).
(Fig.
function used to
(Fig. 9-41) on the
15