Task Macro; Step-By-Step Instructions - Task Macros - Logicube Falcon-NEO User Manual

8.
9.

3.5 Task Macro

This operation allows up to five (5) macros that can be set. Each macro can run up to
nine (9) tasks sequentially (one after another). For example, a macro can be set to
perform these tasks in order: Wipe, Image, and then Hash.
Details on the different screens found
in the Wipe/Format operation can be
found in Section 5.5: Task
3.5.1 Step-By-Step Instructions – Task Macros
Each task or operation must be set up before setting up the macro. For example, to set
up a Task Macro that will perform a wipe, then image, users must first set up both the
wipe and image tasks. Once the wipe (for example, Wipe 1) and image (for example,
Image 1) has been set up, the Task Macro can be set.
1.
2.
3.
4.
®
-Neo User's Manual
Logicube Falcon
Tap the Start icon to start the push task.
When finished, the status will show "COMPLETED". It is recommended to tap
Reset Task to reset the task, so the drive bays properly reset and not show as
being used or assigned for other tasks.
Macro.
Select Task Macro from the types of operation on the left side.
Select a macro (Macro 1 through Macro 5).
Tap the Task icon to select up to nine (9) operations.
Set up to 9 operations by tapping on each operation in order (Operation 1,
Operation 2, etc.)
QUICK START
29