BEA LZR-WIDESCAN Manual page 8

HOW TO ADJUST THE SENSOR BY REMOTE CONTROL
After unlocking, the
red LED flashes and the
sensor can be adjusted
by remote control.
If necessary, select the corresponding detection field before selecting the parameter and changing the
value. The second LED indicates the detection field.
...
MOTION
.
PULL-CORD
....
PRESENCE
..
SAFETY
HOW TO ADJUST THE SENSOR BY LCD
Select your Language before entering the
first LCD menu.
Within the first 30 seconds of power-on of the sensor
or later in the diagnostics menu.
Access advanced adjustments.
More
Parameter
Displayed value = Factory value
Value
Page 8 of 16 Page 8 of 16 Page 8 of 16 Page 8 of 16
If the red LED flashes quickly after unlocking, enter an
access code from 1 to 4 digits. If you do not know the
access code, cycle power.
...
.
....
..
Enter the LCD menu.
Select a folder, parameter, or value.
SHORT Confirm a value and exit edit mode.
PRESS
Activate red spots on floor.
PRESS
2X
Launch POSITION WIZARD.
LONG
PRESS
Activate red spots on floor
Teach-in: install
Teach-in: pull-cord
Presettings
Restoring
Password
Enter a Password if necessary.
X X X X
Go to the Diagnostics menu.
>Diagnostics
Parameter
Value Displayed value = Saved value
75.5916.03 LZR-WIDESCAN 20180821 75.5916.03 LZR-WIDESCAN 20180821 75.5916.03 LZR-WIDESCAN 20180821 75.5916.03 LZR-WIDESCAN 20180821
To end an adjustment session,
always lock the sensor.
.
Return to previous menu or
display.
Scroll up or down.