Adjusting The Hardware; Ruler Adjustment And Rectangularity Adjustment Of The Motion System - Trotec Speedy C12 Service Manual

7. Adjusting the Hardware

Ruler adjustment and rectangularity adjustment of the motion system

The Speedy provides a far developed system of software adjustment. This makes it
also possible to fine adjust the zero position of the rulers precisely without touching
any mechanical component. (Please refer to the chapter software adjustment)
If a software adjustment is not possible (e.g. because the range of adjustment in the
software is too small or the rulers are not parallel to the motion system) you have to
adjust the rulers and/or the motion system.
NORMAL.DOT
max
Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc
I N D I V I D U A L M A R K I N G S Y S T E M S
Gespeichert am:2003/03/10
Version 14
Seite 36 von 87