Operating Instructions; Introduction; Switches And Leds; Abort Switch (S1) - Motorola MVME162 User Manual

Introduction

This chapter provides information necessary to use the MVME162 in a system
configuration. This includes a description of the switches and LEDs, memory
maps, and software initialization of the module.

Switches and LEDs

The MVME162 front panel has
(light-emitting diode) indicators (
).
VME

ABORT Switch (S1)

When enabled by software, the
programmable level. It is normally used to abort program execution and
return to the 162Bug debugger firmware located in the MVME162 EPROM
and Flash memory.
The
ABORT
interrupter connected to the
remove switch bounce.

RESET Switch (S2)

The
RESET
MVME162 is the system controller. The RESET switch may be disabled by
software.
The VMEchip2 includes both a global and a local reset driver. When the
VMEchip2 operates as the VMEbus system controller, the reset driver
provides a global system reset by asserting the VMEbus signal
* may be generated by the
SYSRESET
watchdog timeout, or by a control bit in the LCSR in the VMEchip2.
remains asserted for at least 200 ms, as required by the VMEbus specification.
Similarly, the VMEchip2 provides an input signal and a control bit to initiate
a local reset operation. By setting a control bit, software can maintain a board
in a reset state, disabling a faulty board from participating in normal system
operation. The local reset driver is enabled even when the VMEchip2 is not the
MVME162/D23-1
switch interrupter in the MCchip ASIC is an edge-sensitive
ABORT
switch resets all onboard devices; it also drives
OPERATING
INSTRUCTIONS
and switches and eight LED
ABORT RESET
, , ,
FAIL STAT RUN SCON
switch generates an interrupt at a user-
ABORT
switch. This interrupter is filtered to
switch, a power-up reset, a
RESET
3
, , , ,
LAN FUSE SCSI
* if the
SYSRESET
*. A
SYSRESET
SYSRESET
*