Control Front Panel - Cooper F6-PA-LS Installation And Operation Instructions Manual

Form 6-LS Pole Mount Recloser Control Installation and Operation Instructions

Control Front Panel

The Form 6-LS control front panel is illustrated in Figure 4.
The front panel is separated into two clearly identified,
color-coded sections:
• The top portion of the front panel is used for programming
the control and providing LED status indication.
• The lower portion of the front operating panel is used
for operating the control and recloser.
The control includes a Power Save feature that will turn off
the backlit LCD display and all LEDs (except Hot Line Tag)
if no front panel keypad is pressed within ten minutes.
Pressing the LAMP TEST key will re-activate the display
and LEDs.
Note: The Power Save feature is a ProView interface software
default setting. This feature can be disabled via the
ProView interface software.
The control includes a Reset Menu feature that will cause
the LCD display to revert to the root menu after ten minutes
of inactivity.
The ten minute timer and MMI Reset Menu is a ProView
Note:
interface software default setting. The menu selection
and timer can be changed via the ProView interface
software.
LED Indicators
LCD Menu Function Keys
One-Touch
Analysis Keys
Cursor Movement Arrows
LCD Display
Dedicated
Function Keys
TRIP (LOCKOUT)
Pushbutton
Figure 4.
Form 6-LS control front panel.
6
CONTROL OK
A PHASE FAULT
CONTROL POWER B PHASE FAULT
CONTROL LOCKOUT C PHASE FAULT
RECLOSER OPEN GROUND FAULT
RECLOSER CLOSED SENSITIVE GND
METERING
RESET
TARGETS
F1
EVENTS
MENU
LAMP TEST
ENTER
F6 Recloser Control
TRIP CLOSE
(LOCKOUT)
CLOSE Pushbutton
Front Panel Text Messaging
The LCD messages are accessed from the front panel by
following the Text Messages menu path. This menu
displays any active user-configured text messages.
Up to fourteen user-configurable text messages can be
programmed via the Idea Workbench. Refer to Service
Information S280-70-4 (ProView 4.X.X) or S280-70-21
(ProView 5.X.X) Form 6 Control Programming Guide for
information on programming the text messages.
These text messages appear on the front panel LCD and
can be programmed to appear for alarm or other
conditions.
Text messages displayed on the front panel are limited to
four lines of 20 characters each (including spaces). Text
messages can also be accessed by pressing the LAMP
TEST one-touch analysis key on the front panel.
ALARM A PHASE VOLTAGE
ABOVE MIN TRIP B PHASE VOLTAGE
TIE C PHASE VOLTAGE
SECTIONALIZER FREQUENCY TRIP
VOLTAGE TRIP
LS DISABLED
F2 F3 F4
+
—
ON
NON
GRD TRIP
RECLOSING
BLOCKED
SOURCE I
LS RESET
HOT LINE TAG
ENABLED
OPTION#1 OPTION #2
Hot Line Tag Toggle Switch and
Three-Segment LED Indication
X PHASE VOLTAGE
Y PHASE VOLTAGE
Z PHASE VOLTAGE
INDICATOR 7
INDICATOR 8
LCD Display
SETTINGS
OPER
COUNTER
One-Touch
Analysis Keys
ALARMS
CHANGE
LCD Display
Dedicated
Function Keys
RS-232 DATA PORT
SUPERVISORY
RS-232
OFF
Configuration
SOURCE II
Data Port
ENABLED
One-Touch
OPTION#3
Function Keys