Cisco NCS 4000 Series Troubleshooting Manual page 30

Hide thumbs Also See for NCS 4000 Series:

Table of Contents

Clear the ODUk IAE Alarm

Procedure

Change the IAE bit in the SM overhead field to "0" for 5 consecutive frames.

If the condition does not clear, log into the Technical Support Website at

index.html

ODUk-LCK-PM

Default Severity: Not Alarmed (NA), Service-Affecting (SA)

Logical Object: PORT

ODUk-LCK (Locked) alarm occurs when the upstream connection is locked, and no signal is passed through.

Clear the ODUk LCK PM Alarm

Procedure

Unlock the upstream connection to pass the signal by deleting the shutdown condition (OOS, DSBLD) on

the resource or along the fiber.

If the condition does not clear, log into the Technical Support Website at

index.html

ODUk-OCI-PM

Default Severity: Not Alarmed (NA), Service-Affecting (SA)

Logical Object: PORT

ODUk-OCI (Open Connection Indication) alarm occurs when the upstream signal is not connected to a trail

termination source or incase of incomplete intermediate configurations in the ODUk path. This alarm can also

occur during the ODUk path teardown, where one (or more) ODUk hardware along the path was not removed

from the configuration.

Clear the ODUk-OCI-PM Alarm

Procedure

Check for missing or incomplete configurations on the ODUk path towards the upstream direction of the

connected fiber. Complete the configurations as required.

Alarms Troubleshooting Guide for Cisco NCS 4000 Series

for more information or call Cisco TAC (1 800 553-2447).

Alarm Management

http://www.cisco.com/c/en/us/support/

Table of Contents