Cisco NCS 4000 Series Troubleshooting Manual page 28

Hide thumbs Also See for NCS 4000 Series:

Table of Contents

MEA

• OTUk-SF -

If the condition does not clear, log into the Technical Support Website at

index.html

If the condition does not clear, log into the Technical Support Website at

index.html

MEA

Default Severity: Critical (CR), Service-Affecting (SA)

Logical Object: EQPT

The MEA alarm is reported when the physical card inserted into a slot does not match the card type that is

already provisioned for that slot.

Clear the MEA Alarm

Procedure

Either plug out the card of incorrect card type or delete the pre-configuration and reinsert the card.

If the condition does not clear, log into the Technical Support Website

support/index.html

ODUk-AIS-PM

Default Severity: Not Alarmed (NA), Service-Affecting (SA)

Logical Object: PORT

ODUk - AIS (Alarm Indication Signal) occurs if the accepted STAT information is 111.

Clear the ODUk AIS PM Alarm

Procedure

Identify the root cause alarm which has triggered this alarm. The alarms that could trigger the ODUk AIS PM

alarm are - LOS , LOF. Follow the recommended clearing procedure to clear these alarms.

Also, check for any hardware failure in the upstream direction of the flow where this alarm has been detected.

If the condition does not clear, log into the Technical Support Website at

index.html

Alarms Troubleshooting Guide for Cisco NCS 4000 Series

#unique_63

for more information or call Cisco TAC (1 800 553-2447).

Alarm Management

http://www.cisco.com/c/en/us/support/

athttp://www.cisco.com/cisco/web/

http://www.cisco.com/c/en/us/support/

Table of Contents