Control Unit Atbcontrol © 3 - ATB AQUAmax BASIC series Operation And Maintenance Manual

Operation and maintenance manual AQUAmax
Control unit ATBcontrol
Control unit for the activation of small wastewater treatment plants of the types AQUAmax
/ CLASSIC and AQUAPRIMO
General and safety information
With intended employment of the equipment no hazards whatsoever emanate from the unit.
National applicable regulations and technical data are to be observed.
Should the ATBcontrol
GmbH and/or if the following safety information is disregarded, this can lead to malfunction of or
defects in the plant. In this case any liability is ruled out.
Modifications to the unit are not permitted and lead to the loss of all claims under warranty.
Do not operate any unit which indicates malfunctions, has been dropped or is damaged in any
way.
Features
•
Microprocessor controlled
•
USB connection for data readout and input
•
Splash water protected. Conditionally suitable for outside areas (IP54)
•
Wall mounting
•
Voltage failure detection system (UVS
•
Potential-free contact for an additional alarm facility
•
Simple and rapid operation
•
Times for all parameters completely pre-programmed
•
Automatic run-in phase with suppression of excess sludge removal
•
Parameter settings freely selectable
•
Alarm interval
•
Alarm volume adjustable
•
Deployable for AQUAmax
•
Plug-in
•
Winter operation and sludge removal mode for the reduction of the aeration times
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0210 / Status: 30.01.2019 / Page 8 from 40
©
3
©
3 be used for other purposes without the express approval of ATB WATER
®
®
BASIC / CLASSIC and AQUAPRIMO
®
BASIC/CLASSIC
)
® BASIC