1MRS755014
3.3.3.2.
3.3.3.3.
Profibus-DPV1/SPA Gateway
Installation and Commissioning
SPA bus communication speeds
Table 3.3.3.2-1 Communication speeds
Baud rates supported
1.2 kbit/s
2.4 kbits/
4.8 kbit/s
9.6 kbit/s
19.2 kbit/s
38.4 kbit/s
The SPA baud rates can be set through the Profibus-DPV1/SPA Configuration Tool
(PCT), to match the connected relay. If several relays are connected, they all use one
common baudrate.
DIP switch configuration
The SPA interface is configured by using DIP switches located beside the DSUB9
connectors. To select the correct DIP switch number, follow the instructions in
Table 3.3.3.3-1 and see Fig. 3.3.3.3.-2:
For the safety, set the active DIP switches to OFF position before
switching on the new settings when changing the interface type.
Only one interface type must be active at a time. The state of the DIP
switches can be changed without turning the power off.
The smaller group of DIP switches is referred to as group A, and the
larger group as group B, see Fig. 3.3.3.3.-2.
Fig. 3.3.3.3.-1 DIP switch configurations A1-4 and B1-8
The DIP switches A1-4 and B1-8, see Fig. 3.3.3.3.-1, are described in
Table 3.3.3.3-1
SPA-ZC 302
A050336
19