Step 5. Wiring the DC Outputs
Please follow the steps below to insert the power wires for DC power required
equipment.
1. Please find the terminal block connector with two DC power outputs shown
below:
V1+
V2+
V1-
V2-
2. Insert the Positive and Negative DC wires into the V+ and V- terminals, respec-
tively; Terminals 1 and 3 for Power 1, and Terminals 2 and 4 for Power 2.
3. Connect the other points of DC power wires to the power devices. Tighten the
wire-clamp screws for preventing the wires from loosening.
14
V1+
V2+
V1-
V2-
One Powered Device
V1+
V2+
V1-
V2-
Two Powered Devices
Powered
Device 1
Maximum Output 24 Watts
Powered
Device
1
Total Maximum
Output 24 Watts
Powered
Device
2