Planet Networking & Communication BSP-360 Quick Installation Manual page 16

Industrial renewable energy, industrial solar power 5-port gigabit managed switch with 4-port 802.3at poe plus

Hide thumbs Also See for BSP-360:

Table of Contents

4. Install the terminal block on the BSP-360.

 The voltage of DC out is based on the battery voltage and the

maximum DC out from the BSP-360 is 24VDC, 1A.

 The wire gauge for the terminal block should be in the range

from 14 to 24 AWG.

Note

 The external device should also be grounded properly.

Please ensure the output voltage is correct for remote device.

Otherwise, it will damage your remote device.

Step 6. Connect to PC

IP Address:

192.168.0.x

After completing the above 6 steps, the BSP-360 is ready for service.

RJ45/UTP Cable

IP Address:

192.168.0.100

Table of Contents