THORLABS KST101 User Manual page 71

SetMotorParams
SetPhaseCurrents
SetPositionOffset
SetPotParams
SetRelMoveDist
SetStageAxisInfo
SetVelParams
ShowSettingsDlg
StartCtrl
StopCtrl
StopImmediate
StopProfiled
Properties
APTHelp
DisplayMode
HWSerialNum
Sets the motor gearing parameters.
Sets the coil phase currents.
Sets the motor position offset.
Sets the velocity control potentiometer parameters
(Cube drivers).
Sets the relative move distance.
Sets the stage axis parameters.
Sets the velocity profile parameters.
Display the GUI Settings panel.
Starts the ActiveX Control (starts communication
with controller)
Stops the ActiveX Control (stops communication
with controller)
Stops a motor move immediately.
Stops a motor move in a profiled (decelleration)
manner.
Specifies the help file that will be accessed when the
user presses the F1 key. If APTHelp is set to 'True',
the main server helpfile MG17Base will be launched.
Allows the display mode of the virtual display panel
to be set/read.
specifies the serial number of the hardware unit to
be associated with an ActiveX control instance.
K-Cube Stepper Motor Controller
71