Preventative Maintenance Schedule - Malmet Energy Saver ES910 Operation, Maintenance And Installation Manual

Bed Pan Flusher / Sanitizer - Energy Saver
With Hands Free Operation
Operation, Maintenance and Installation Manual
Recommended Preventative Maintenance Schedule
(to be performed by a qualified maintenance person)
To be performed THREE TIMES YEARLY for units in constant day and night use and HALF
YEARLY for units in lesser usage situations.
ISOLATE UNIT FROM ELECTRIC SUPPLY BEFORE SERVICING
a) Remove top and side panels and front bottom panel.
Note: Panel removal
b) Remove three sprays, two bottle hooks and rotary nozzle from inside the chamber – check
that the holes are clear and clean as necessary (hold under tap and pressurise or clean in
ultrasonic cleaner). In areas with hard water or high minerals in water supply, chemical de-
scaler may be the quickest and easiest means to remove built up deposits. Replace sprays
and bottle hooks.
c) Start cycle and check that cold water pump is working, 17 seconds of the cycle.
d) After ascertaining that the pump is working properly, check the solenoid operation in the
cold water tank. Check steam sensor (steam generator) maintenance.
e) Make sure the solenoids are completely shutting off and levels are not creeping up, if so,
clean and/or replace the solenoid.
f) Tighten the screws retaining the pan rack on the door.
ONLY IF NECESSARY AFTER VISUAL CHECK
a) Clean dust and grit off components.
Malmet will make available on request circuit diagrams, component parts lists, descriptions,
calibration instructions, or information which will assist the user's appropriately qualified technical
personnel to repair those parts of the
Issue 24
WARNING 240 VOLTS
i) Remove 2 self-tapping screws on the top panel.
ii) Push the side panel back then lift up to remove.
iii) Remove 2 x 3/16" screws from bottom front panel.
product.
16
Page
rd
23 August 2013