Malmet Energy Saver ES910 Operation, Maintenance And Installation Manual page 12

Bed Pan Flusher / Sanitizer - Energy Saver
With Hands Free Operation
Operation, Maintenance and Installation Manual
9. Once the wash cycle is complete the display will flash 90 (indicating 90° C). This is the
critical temperature that must be reached before the sanitation cycle can commence. At
this point the fill solenoid is disabled and will not operate unit Step 12.
10. The elements in the steam generator heat to produce steam, which is directed into the
wash chamber raising the internal cabinet temperature above 90° C.
11. Once the internal cabinet temperature has reached 90° C the sanitization cycle will
commence. This display shows the actual cabinet temperature.
12. All 3 elements on 20 amp models and on all 2 elements on 10 amp models will continue to
heat during the sanitization cycle until the internal cabinet temperature reaches 91° C.
13. At 91° C one element will turn off and at 92° C a nother element will turn off on
models, on 10 amp models at 91° C one element will t urn off. One element will remain on
until 15 seconds before the end of the cycle. If the internal cabinet temperature falls below
92° C the second element is turned back on the third respectively if the cabinet temperature
falls below 91° C.
Note: Regardless of element combinations 15 seconds before the end of the cycle ALL
elements will turn off. This is to overcome the effects of overshoot in the steam
generator producing steam at the end of the sanitization cycle.
14. The maximum time allowable for the sanitization cycle is 10 minutes.
exceeded then the machine will go to fault and elements turn off.
Issue 24
ACTUAL
CABINET TEMP.
12
Page
20 amp
If this time is
rd
23 August 2013