Section B - Unit Maintenance; Preventative Maintenance Schedule - Malmet Energy Saver ES910 Operation, Maintenance And Installation Manual

Bedpan Washer Disinfector - Energy Saver
Detergent Model With Hands Free Operation
Operation, Maintenance and Installation Manual
Section B – Unit Maintenance
A qualified person should carry out all maintenance, preventative or breakdown. Failure to comply with
this condition may result in unsafe conditions.
The Malmet 'Energy Saver' is self-cleaning, but proper care should be taken to ensure that the unit is
cleaned and maintained in accordance with the maintenance instructions for Malmet Bedpan Washer
Disinfectors and in accordance with all other regulatory and commonsense practices.

Preventative Maintenance Schedule

Daily Maintenance (Operator or Maintenance Technician)
a) Wipe out the inside of the door and chamber with warm water and detergent. A wipe with
disinfectant is also desirable.
b) Wipe over outside stainless steel panels with a stainless steel cleaner.
c) Wipe the front control panel with a soft cloth and mild detergent as necessary. Care should be
taken not to damage the digital display or to activate a cycle.
d) Check level in detergent bottle, replenish as necessary.
Bi-Monthly (Maintenance Technician)
a) Check for steam or water leaks. Tighten union, hose clamps and glands where necessary.
b) Remove and clean out sprays and bottle hooks (unscrew from inside chamber). Clean in ultrasonic
cleaner if available.
c) Remove level probe in steam generator tank and clean off any build up of residue.
d) Remove temperature probes in steam tank and chamber and clean off any build up of residue.
e) Visually inspect build-up of residue in steam tank, especially in areas of poor water quality.
f) Check filter in the water inlet solenoid valve and clean as necessary.
g) Check and tighten, if necessary, all electrical connections
Stainless Steel Maintenance/Care
Under normal usage, stainless steel products require regular cleaning with a soft clean rag moistened
with a mild detergent followed by a water moistened clean rag and then a dry rag.
The #4 satin finish steel should be protected against Muriatic acid and caustic or abrasive materials and
harsh cleaning detergents. In the event such agents cause discoloration, polish with a stainless steel
cleaner such as 3M Stainless Steel Cleaner & Polish and 3M Scotch Brite pad.
Issue 21 Page 18 14 September 2017