Section B - Unit Maintenance - Malmet Energy Saver ES910 Operation, Maintenance And Installation Manual

Bed Pan Flusher / Sanitizer - Energy Saver
With Hands Free Operation
Operation, Maintenance and Installation Manual
Section B – Unit Maintenance
A qualified person should carry out all maintenance, preventative or breakdown. Failure to
comply with this condition may result in unsafe conditions.
The Malmet 'Energy Saver' is self-cleaning, but proper care should be taken to ensure that the unit
is cleaned and maintained in accordance with the maintenance instructions for Malmet Flusher /
Sanitizers and in accordance with all other regulatory and commonsense practices.
Preventative Maintenance Schedule
Daily Maintenance (Operator or Maintenance Technician)
a) Wipe out the inside of the door and chamber with warm water and detergent. A wipe with
disinfectant is also desirable.
b) Wipe over outside stainless steel panels with a stainless steel cleaner.
c) Wipe the front control panel with a soft cloth and mild detergent as necessary. Care should
be taken not to damage the digital display or to activate a cycle.
d) Check level in detergent bottle, replenish as necessary (Detergent Models Only)
Bi-Monthly (Maintenance Technician)
a) Check for steam or water leaks. Tighten union, hose clamps and glands where necessary.
b) Remove and clean out sprays and bottle hooks (unscrew from inside chamber). Clean in
ultrasonic cleaner if available.
c) Remove level probe in steam generator tank and clean off any build up of residue.
d) Remove temperature probes in steam tank and chamber and clean off any build up of
residue.
e) Visually inspect build up of residue in steam tank, especially in areas of poor water quality.
f) Check filter in the water inlet solenoid valve and clean as necessary.
g) Check and tighten, if necessary, all electrical connections
Stainless Steel Maintenance/Care
Under normal usage, stainless steel products require regular cleaning with a soft clean rag
moistened with a mild detergent followed by a water moistened clean rag and then a dry rag.
The #4 satin finish steel should be protected against Muriatic acid and caustic or abrasive
materials and harsh cleaning detergents. In the event such agents cause discoloration, polish with
a stainless steel cleaner such as 3M Stainless Steel Cleaner & Polish and 3M Scotch Brite pad.
Issue 24
15
Page
rd
23 August 2013