Failure Codes And What To Do In Case Of Failure; Practical And Useful Information - Westinghouse WSF6606 User Manual

FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

F1 Leak detection
F2
Draining fault
F3 Water overfill
F5 Water supply fault
F6
Faulty heater sensor
F7
Overheating (water temperature too high)
F8
Not heating
F9 Flow control position error
FE
Power supply fault
H01 – H24
Delay has been selected

PRACTICAL AND USEFUL INFORMATION

1 Whenever you will not be operating your machine:
• Unplug the machine and then turn the water
off .
• Leave the door slightly ajar in order to prevent
the formation of unpleasant odours .
• Keep the machine interior clean .
2 Eliminating water droplets:
• Wash the dishes with the intensive program .
• Increase the rinse aid setting .
• If plastic items are washed, water drops on these
items will be unavoidable . Programs with higher
temperatures and increased rinse aid settings
may reduce the water drops . Check that the
plastic items are suitable for dishwasher use .
3 Correctly loaded dishes will give the best energy
• Switch off the dishwasher and close the tap .
• Contact the service centre .
• Cancel program and power off machine, then check the following .
• Spigot on sink trap is clogged .
• Check if the drain spigot membrane has been removed .
• Drain hose is clogged .
• Filters of the dishwasher may be clogged .
• If error continues contact the service centre .
• Close the tap .
• Contact the service centre .
• Make sur e the water tap is open and the main water supply is on .
• Close he tap, disconnect the hose and clean the filter at the tap
connection end .
• Check the inlet hose is not kinked .
• If error continues contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Restart the dishwasher .
• Cancel the delay setting .
consumption, washing and drying performance .
4 Scrape off food soils before you place dirty dishes
in the machine .
5 Operate the machine after it is completely full .
6 Use pre-washing program only when necessary .
7 Observe program information and average
consumption values table when selecting a
program .
8 Since the machine will reach high temperatures,
it should not be installed near a refrigerator .
9 If the appliance is located where the risk of freezing
exists, you must completely drain the water that
has remained in the machine . Turn off the water tap,
disconnect the water inlet hose from the tap and
allow the interior water to drain .
MAINTENANCE AND CLEANING
MAINTENANCE
23