FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE
ERROR CODE
F1
F2
F3
F5
F6
F7
F8
F9
FE
H01 – H24
PRACTICAL AND USEFUL INFORMATION
1 Whenever you will not be operating your machine:
•
Unplug the machine and then turn the water off
•
Leave the door slightly ajar in order to prevent the
formation of unpleasant odours
•
Keep the machine interior clean
2 Eliminating water droplets:
•
Wash the dishes with the intensive program
•
Increase the rinse aid setting
•
If plastic items are washed, water drops on these
items will be unavoidable Programs with higher
temperatures and increased rinse aid settings may
reduce the water drops Check that the plastic
items are suitable for dishwasher use
3 Correctly loaded dishes will give the best energy
consumption, washing and drying performance
FAILURE CODES
24
ERROR DESCRIPTION
Leak detection
Draining fault
Water overfill
Water supply fault
Faulty heater sensor
Overheating (water temperature too high)
Not heating
Flow control position error
Power supply fault
Delay has been selected
CONTROL
• Switch off the dishwasher and close the tap
• Contact the service centre
• Cancel program and power off machine, then check the following
• Spigot on sink trap is clogged
• Check if the drain spigot membrane has been removed
• Drain hose is clogged
• Filters of the dishwasher may be clogged
• If error continues contact the service centre
• Close the tap
• Contact the service centre
• Make sur e the water tap is open and the main water supply is on
• Close he tap, disconnect the hose and clean the filter at the tap
connection end
• Check the inlet hose is not kinked
• If error continues contact the service centre
• Contact the service centre
• Contact the service centre
• Contact the service centre
• Contact the service centre
• Restart the dishwasher
• Cancel the delay setting
4 Scrape off food soils before you place dirty dishes in
the machine
5 Operate the machine after it is completely full
6 Use pre-washing program only when necessary
7 Observe program information and average consumption
values table when selecting a program
8 Since the machine will reach high temperatures,
it should not be installed near a refrigerator
9 If the appliance is located where the risk of freezing
exists, you must completely drain the water that has
remained in the machine Turn off the water tap,
disconnect the water inlet hose from the tap and allow
the interior water to drain