Failure Codes And What To Do In Case Of Failure; Practical And Useful Information - Westinghouse WSF6608 User Manual

fAiLURE codES ANd WHAT To do iN cASE of fAiLURE

ERRoR codE
F5
F3
F2
F8
F1
FE
F7
F9
F6

pRAcTicAL ANd USEfUL iNfoRMATioN

1 Whenever you will not be operating your machine:
• Unplug the machine and then turn the water off.
• Leave the door slightly ajar in order to prevent the
formation of unpleasant odours.
• Keep the machine interior clean.
2 Eliminating water droplets:
• Wash the dishes with the intensive program.
• Increase the rinse aid setting.
• If plastic items are washed, water drops on these
items will be unavoidable. Programs with higher
temperatures and increased rinse aid settings may
reduce the water drops. Check that the plastic
items are suitable for dishwasher use.
3 Correctly loaded dishes will give the best energy
consumption, washing and drying performance.
FAILURE CoDES
24
ERRoR dEScRipTioN
Inadequate water supply
Error of continuous water input
The waste water in the machine cannot be
discharged
Heater error
Alarm is active against water overflow
Faulty electronic card
Overheating error (temperature in the
machine is too high)
Flow Control Valve position error
Faulty heater sensor
coNTRoL
• Make sure the water tap is open and that main water supply is
on.
• Close the water tap, separate the water inlet hose from the tap
and clean the filter at the connection end of the hose.
• Restart your machine, contact the service centre if the error
resumes.
• Close the tap.
• Contact the service centre.
• Water drain hose is clogged.
• Spigot on sink tap is blocked.
• The filters of your machine might be clogged.
• Power off your machine and activate the program cancellation
command.
• Check the drain spigot's membrane has been removed or
blocked.
• If the error continues, contact the service centre.
Contact the service centre.
• Power off your machine and close the tap.
• Contact the service centre .
• Contact the service centre.
• Contact the service centre.
• Contact the service centre.
• Contact the service centre.
4 Clean all rough waste before you place dirty dishes in
the machine.
5 Operate the machine after it is completely full.
6 Use pre-washing program only when necessary.
7 Observe program information and average
consumption values table when selecting a program.
8 Since the machine will reach high temperatures, it
should not be installed near a refrigerator.
9 If the appliance is located in a place where the risk
of freezing exists, you must completely drain the water
that has remained in the machine. Turn off the water
tap, disconnect the water inlet hose from the tap and
allow the interior water to drain.
FAILURE CoDES